中国有色金属学报(英文版)
Transactions of Nonferrous Metals Society of China
| Vol. 33 No. 6 June 2023 |
（1. School of Metallurgy, Northeastern University, Shenyang 110819, China;
2. Institute for Frontier Technologies of Low-carbon Steelmaking, Northeastern University, Shenyang 110819, China;
3. Liaoning Province Engineering Research Center for Technologies of Low-Carbon Steelmaking, Northeastern University, Shenyang 110819, China;
4. State Key Laboratory of Rolling and Automation, Northeastern University, Shenyang 110819, China）
Abstract:By using the central composite design based on the response surface method, the multiobjective collaborative optimization of Fe, Cr and Ni metal recovery from stainless steel dust and laterite nickel ore was achieved through carbothermal reduction, and a high metal recovery rate and high-grade Fe-Cr-Ni-C alloy particles were obtained. The addition of laterite nickel ore and reduction temperature exert significant effects on the metal recovery, and a significant interaction is observed among the recoveries of the metals Fe, Cr and Ni in the reduction products. The optimal process parameters obtained through the optimization of the model are listed as follows: the amount of added laterite nickel ore is 5.47%, the reduction temperature is 1428.02 °C, the reduction time is 23.10 min, and the carbon oxygen ratio (FC/O) is 0.85. The predicted results for Fe, Cr and Ni recovery using the model are 93.15%, 91.63% and 92.70%, respectively.
Key words: stainless steel dust; laterite nickel ore; metal recycling; response surface methodology; Fe-Cr-Ni-C alloy particles
