中国有色金属学报(英文版)
Transactions of Nonferrous Metals Society of China
| Vol. 32 No. 8 August 2022 |
（1. School of Mechanical Engineering, University of Science and Technology Beijing, Beijing 100083, China;
2. Shunde Graduate School, University of Science and Technology Beijing, Foshan 528300, China;
3. School of Materials Science and Engineering, University of Science and Technology Beijing, Beijing 100083, China;
4. Institute for Engineering Technology, University of Science and Technology Beijing, Beijing 100083, China;
5. State Key Laboratory of Materials Processing and Die & Mould Technology, School of Materials Science and Engineering, Huazhong University of Science and Technology, Wuhan 430074, China）
Abstract:The effects of laser power and scanning speed on the forming characteristic of scanning tracks, densification behaviours and surface roughness of pure nickel fabricated with selective laser melting (SLM) were studied. The results indicate that the scanning tracks showed continuous, regular and flat surface with increasing laser power and decreasing scanning speed in a specific range, which could avoid the defects (like holes and balling structures) forming in SLM processing. The optimal process window was identified as the scanning speed of 900 mm/s and the laser power of 255-275 W by comparing the surface qualities and densification behaviours. With the suitable processing parameters, the relative density could achieve 99.16%, the tensile strength was (359.49±2.74) MPa, and the roughnesses of the top and side surfaces were (12.88±2.23) and (14.98±0.69) μm, respectively.
Key words: selective laser melting; pure nickel; scanning track; densification; surface roughness
