中国有色金属学报(英文版)
Transactions of Nonferrous Metals Society of China
| Vol. 31 No. 5 May 2021 |
（1. School of Materials Science and Engineering, Central South University, Changsha 410083, China;
2. Aerospace Research Institute of Materials and Processing Technology, Beijing 100076, China;
3. Monash Centre for Additive Manufacturing, Monash University, Clayton 3800, Australia;
4. School of Chemistry and Chemical Engineering, Ningxia University, Yinchuan 750021, China）
Abstract:The effect of microstructure evolution on the tensile properties of 2050 Al-Li alloy thick plate aged at 150 °C with 80 mm in thickness (t) was studied from a microstructural perspective. Scanning electron microscope, optical microscope, transmission electron microscope and X-ray diffractometer were used to explore the surface (t/6), interlayer (t/3) and center (t/2) thickness layer of this alloy. Results show that the secondary phases on grain boundaries, precipitates and textures vary depending on the thickness location. The precipitation strengthening has a stronger influence on the alloy along the rolling direction than the transverse direction from the under-aged to the peak-aging condition; however, its effect on the anisotropy is insignificant. The higher Taylor factor (M) value caused by stronger β fiber rolling textures and the intergranular phases is the main reason that leads to the highest strength at the t/2 position along the rolling direction. The M-value has a limited change at different thickness layers along the transverse direction, which causes the same tensile strength.
Key words: 2050 Al-Li alloy; tensile properties; anisotropy; precipitate; texture
