Transactions of Nonferrous Metals Society of China The Chinese Journal of Nonferrous Metals

您目前所在的位置:首页 - 期刊简介 - 详细页面

中国有色金属学报

ZHONGGUO YOUSEJINSHU XUEBAO

第27卷    第11期    总第224期    2017年11月

[PDF全文下载]        

    

文章编号:1004-0609(2017)-11-2276-07
Y2O3掺杂BaZrO3显微组织演变及与钛熔体相容性
周路海1,陈光耀1,李宝同1,程治玮3,ALI Wajid1,鲁雄刚1, 2,李重河1, 2

(1. 上海大学 材料科学与工程学院,省部共建高品质特殊钢冶金与制备国家重点实验室,上海市钢铁冶金新技术开发应用重点实验室,上海 200072; 2. 上海特种铸造工程技术研究中心,上海 201605; 3. 舍弗勒有限公司,太仓 215400)

摘 要: 以BaCO3、ZrO2和Y2O3为原料的6种配比混合料在1200 ℃经固相合成Y2O3掺杂BaZrO3粉体,并经冷等静压成型后在1750 ℃烧结成圆片。利用X射线衍射仪(XRD)和扫描电子显微镜(SEM)结合能谱分析(EDS)分析不同Y2O3掺杂量对BaZrO3粉体组成及其对BaZrO3圆片的显微组织结构和烧结性能的影响。结果表明:Y2O3掺杂BaZrO3主要由BaZrO3和Ba2YZrO6构成;随着Y2O3掺杂量的增加,Ba2YZrO6含量逐渐增加,并出现团聚现象;同时,BaZrO3晶粒生长受到抑制,导致圆片表面疏松多孔,致密度降低。当原料摩尔比n(BaCO3):n(ZrO2):n(Y2O3)=0.48:0.47:0.1时,所获圆片相对密度达到97.1%。使用该配比粉料制备坩埚感应熔炼TiNi合金后,合金与坩埚无界面反应层存在,也未见明显坩锅组成元素向合金扩散现象,说明Y2O3掺杂BaZrO3是一种非常有潜力的钛合金熔炼制备用耐火材料。

 

关键字: 氧化钇;锆酸钡;掺杂;显微组织;界面反应

Microstructure evolution of Y2O3 doped BaZrO3 and its interface reaction with titanium melt
ZHOU Lu-hai1, CHEN Guang-yao1, LI Bao-tong1, CHENG Zhi-wei3, ALI Wajid1, LU Xiong-gang1, 2, LI Chong-he1, 2

1. State Key Laboratory of Advanced Special Steel, Shanghai Key Laboratory of Advanced Ferrometallurgy, School of Materials Science and Engineering, Shanghai University, Shanghai 200072, China; 2 Shanghai Special Casting Engineering Technology Research Center, Shanghai 201605, China; 3. Sflyxgs. Chinaepu. Co., Ltd., Taicang 215400, China

Abstract:Six ratios of Y2O3 doped BaZrO3 powder were prepared from BaCO3, ZrO2 and Y2O3 as raw materials by solid reaction method at 1200 ℃. Then, the pellets were fabricated by cold isostatic pressing and sintered at 1750 ℃. The effect Y2O3 on the constituents of BaZrO3 powder and microstructure evolution of BaZrO3 pellets was studied by using the X-ray diffraction (XRD) and scanning electron microscopy (SEM) combined with EDS. The results show that the Y2O3 doped BaZrO3 mainly consists of two phases, i. e., BaZrO3 and Ba2YZrO6. The content of Ba2YZrO6 increases gradually and the phenomenon of aggregation appears as the amount of Y2O3 increasing. At the same time, the growth of BaZrO3 grains are restrained, the grain boundaries of BaZrO3 and Ba2YZrO6 transform from regular polyhedron boundary to irregular amorphous grain boundary, which make the surface of the pellets porous and lower dense. When the mole ratio of BaCO3, ZrO2 and Y2O3 is about 0.48:0.47:0.1, the relative density of pellets reaches to 97.1%. This proportion of powder was prepared into crucible and utilized to melt TiNi alloys using vacuum induction. There is no obvious interaction layer and elements diffusion between the crucible and the melt, which may imply that the Y-doped BaZrO3 refractory is a promising candidate for melting titanium alloys.

 

Key words: yttria; barium zirconate; doping; microstructure: interfacial reaction

ISSN 1004-0609
CN 43-1238/TG
CODEN: ZYJXFK

ISSN 1003-6326
CN 43-1239/TG
CODEN: TNMCEW

主管:中国科学技术协会 主办:中国有色金属学会 承办:中南大学
湘ICP备09001153号 版权所有:《中国有色金属学报》编辑部
------------------------------------------------------------------------------------------
地 址:湖南省长沙市岳麓山中南大学内 邮编:410083
电 话:0731-88876765,88877197,88830410   传真:0731-88877197   电子邮箱:f_ysxb@163.com