中国有色金属学报(英文版)
Transactions of Nonferrous Metals Society of China
| Vol. 25 No. 8 August 2015 |
（1. Young Researchers and Elite Club, South Tehran Branch, Islamic Azad University, Tehran, Iran;
2. Advanced Materials and Nanotechnology Research Center, Department of Mechanical Engineering,
K. N. Toosi University of Technology, Tehran, Iran;
3. Department of Engineering, Karaj Branch, Islamic Azad University, Karaj, Iran）
Abstract:The fabrication of high strength Al 7068-5%TiC (mass fraction) nanocomposite was studied by mechanical alloying and hot pressing routes. Considering densification importance and grain growth effects, hot pressing process conditions for producing bulk nanocomposite were optimized using statistical Taguchi method based on compressive strength achievement. The Taguchi results indicate that 30 min hot pressing under pressure of 500 MPa at 385 °C provides high compressive strength and hardness of 938 MPa and HV 265, respectively. More interestingly, analysis of variance proves that the applied pressure is the most influential factor for hot pressing of the nanocomposite. The contribution percentages of factors in hot pressing terms are as follows: applied pressure (61.3%), exposed temperature (29.53%) and dwelling hot pressing time (4.49%).
Key words: Al 7068-TiC nanocomposite; hot pressing; mechanical alloying; Taguchi method; mechanical properties
