中国有色金属学报(英文版)
Transactions of Nonferrous Metals Society of China
| Vol. 25 No. 1 January 2015 |
（1. Faculty of Chemical Engineering and Environmental Protection,
Gheorghe Asachi Technical University of Iasi, Iasi 700050, Romania;
2. Faculty of Materials Science and Engineering,
Gheorghe Asachi Technical University of Iasi, Iasi 700050, Romania;
3. Faculty of Physics, Alexandru Ioan Cuza University of Iasi, Iasi 700506, Romania;
4. INSA Rennes, UMR CNRS 6226 Sciences Chimiques de Rennes/Chimie-Métallurgie F-35043,
Rennes Cedex, France）
Abstract:The electrochemical behaviours of unrecrystallized and recrystallized Ti12Mo5Ta alloys were compared with those of the unrecrystallized Ti12Mo alloy and commercial pure titanium (cp-Ti). Experiments were carried out using physiological 0.9% NaCl solution (pH 2.3) at 37 °C. Very low passive current densities (in order of 10-6 A/cm2) were obtained from the anodic polarization curves, indicating high resistances of all samples in acidified 0.9% NaCl solution. Scanning electron microscopy (SEM) was employed to observe the surface morphology and all sample surfaces were identically corroded, no pitting, cracks, or other defects appeared on the sample surfaces after anodic potentiodynamic polarization tests. Equivalent circuit was used for modeling the electrochemical impedance spectroscopy (EIS) data, in order to characterize the sample surface and better understand the effect of Mo and Ta addition on the cp-Ti and the effect of recrystallization. The EIS results confirm that all titanium samples exhibit passivity in physiological 0.9% NaCl solution (pH 2.3) at open circuit potential (polarization resistance is around 105 Ω？cm2). The corrosion resistance of these samples in physiological 0.9% NaCl solution (pH 2.3) at 37 °C is in the following order of recrystallized Ti12Mo5Ta> unrecrystallized Ti12Mo5Ta > unrecrystallized Ti12Mo > cp-Ti.
Key words: titanium alloys; recrystallization; anodic potentiodynamic curve; Ta; Mo; electrochemical behavior
