Transactions of Nonferrous Metals Society of China The Chinese Journal of Nonferrous Metals

您目前所在的位置:首页 - 期刊简介 - 详细页面

中国有色金属学报

ZHONGGUO YOUSEJINSHU XUEBAO

第12卷    第6期    总第51期    2002年12月

[PDF全文下载]        

    

文章编号:1004-0609(2002)06-1162-05
防锈铝LF6的固态塑性连接工艺
邢 丽, 柯黎明, 周细应, 刘鸽平

(南昌航空工业学院 材料科学与工程系,南昌 330034)

摘 要: 针对防锈铝LF6研究了搅拌摩擦焊焊接规范对焊缝成型及接头力学性能的影响, 分析了搅拌摩擦焊缺陷产生的原因。 结果表明, LF6(M)搅拌摩擦焊接头强度可以达到母材的强度, 其背弯和正弯角度可达到180°; 焊接规范对接头的力学性能有影响, 存在一个最佳力学性能规范区; 某些规范条件下可能出现单边沟槽或隧道型缺陷, 它们的位置与搅拌头的旋转方向有关。

 

关键字: 防锈铝; 固态塑性连接; 搅拌摩擦焊

Solid-state plasticized joining for aluminumalloy LF6
XING Li, KE Li-ming, ZHOU Xi-ying, LIU Ge-ping

Department of Materials Science and Engineering,
 Nanchang Institute of Aero Technology,Nanchang 330034, China

Abstract:Friction stir welding(FSW) is a rather new solid-state joining process, usually for joining low melting temperature alloy. The typical LF6 aluminum alloy was joined by using FSW process. The influences of welding conditions on the weld appearance and mechanical properties were investigated. The reasons of forming defect in FSW were analyzed. It is shown that the strength of the joint can reach that of the parent materials, the bending angle can reach 180°. The mechanical properties of the joint are related to the welding variables, and there is a region in which the mechanical properties are higher than 90% of the parent materials. In some welding conditions, some special appearance, such as groove on one side of the weld surface or channel in the weld, may occur, whose position is related to the rotation direction of the pin.

 

Key words: aluminum alloy; friction stir welding; solid-state joining

ISSN 1004-0609
CN 43-1238/TG
CODEN: ZYJXFK

ISSN 1003-6326
CN 43-1239/TG
CODEN: TNMCEW

主管:中国科学技术协会 主办:中国有色金属学会 承办:中南大学
湘ICP备09001153号 版权所有:《中国有色金属学报》编辑部
------------------------------------------------------------------------------------------
地 址:湖南省长沙市岳麓山中南大学内 邮编:410083
电 话:0731-88876765,88877197,88830410   传真:0731-88877197   电子邮箱:f_ysxb@163.com