中国有色金属学报(英文版)
Transactions of Nonferrous Metals Society of China
| Vol. 21 No. 10 October 2011 |
Cu matrix composite reinforced by carbon nanotubes
（1. State Key Laboratory of Solidification Processing, Northwestern Polytechnical University, Xi’an 710072, China;
2. Engineering School, Shanxi Datong University, Datong 037003, China）
Abstract:Cu matrix composite reinforced with 10% (volume fraction) carbon nanotubes (CNTs/Cu) and pure Cu bulk were prepared by powder metallurgy techniques under the same consolidation processing condition. The effect of electrical current on tribological property of the materials was investigated by using a pin-on-disk friction and wear tester. The results show that the friction coefficient and wear rate of CNTs/Cu composite as well as those of pure Cu bulk increase with increasing the electrical current without exception, and the effect of electrical current is more obvious on tribological property of pure Cu bulk than on that of CNTs/Cu composite; the dominant wear mechanisms are arc erosion wear and plastic flow deformation, respectively; CNTs can improve tribological property of Cu matrix composites with electrical current.
Key words: CNTs/Cu composite; pure Cu bulk; electrical current; tribological property
