中国有色金属学报(英文版)
Transactions of Nonferrous Metals Society of China
| Vol. 21 Special 1 March 2011 |
surface defects in wire drawing process
（1. Department of Mechanical Engineering, Dong-A University, Busan, 604-714, Korea;
2. Department of Mechanical Engineering, Chung-Ang University, Seoul, 156-756, Korea;
3. Wire Rod Research Group, POSCO Technical Research Laboratories, Pohang, 790-785, Korea）
Abstract:A pilot wire drawing machine as well as wire end-pointing roller was developed. Using these machines, a wire drawing test for four different coating materials and two different lubricants was performed as the reduction ratio increased from 10% to 30%. Materials used for a substrate in this study are plain carbon steel (AISI1045) and ultra low carbon bainite steel. To compute the friction coefficient between the coating layer of wire and the surface of die for a specific lubricant, a series of finite element analyses were carried out. SEM observations were also conducted to investigate the surface defects of wire deformed. Results show that the behavior of drawing force varies with the lubricant-type at the initial stage of drawing. The powder-typed lubricant with a large particle causes the retardation of full lubrication on the entire contact surface and the local delamination of coating layer on the wire surface. As the flow stress of a substrate increases, the delamination becomes severe.
Key words: coating; lubricant; wire drawing; delamination
