Transactions of Nonferrous Metals Society of China The Chinese Journal of Nonferrous Metals

您目前所在的位置:首页 - 期刊简介 - 详细页面


Transactions of Nonferrous Metals Society of China

Vol. 25    No. 2    February 2015

[PDF Download]    [Flash Online]    


Process parameters optimization of Ti-6Al-4V alloy sheet during hot stretch-creep forming
Jun-jie XIAO1,2, Dong-sheng LI2, Xiao-qiang LI2, Pan DING2, Kai ZHAO2, Xuan-zhao HUANG2, Ming-jin XU1

1. School of Mechanical and Electrical Engineering, Beijing Institute of Graphic Communication,
Beijing 102600, China;
2. School of Mechanical Engineering and Automation, Beihang University, Beijing 100191, China

Abstract:Hot stretch-creep forming (SCF) is a novel technique to produce hard-to-form thin-walled metal components. Comprehensively considering the analysis results of the springback angle, yield strength and microstructure, four hot SCF process parameters including temperature, stretch velocity, post stretch percentage and dwelling time of a Ti-6Al-4V alloy sheet were optimized using an orthogonal experiment. The results reveal that temperature is the most important factor on springback angle. The yield strength of the deformed material in 0° direction increases, while those in directions of 45° and 90° fluctuate around the original value. After hot SCF, the shape of some a phases changes from short thin grains to long slender ones, and the microhardness changes very little. The optimized parameters with temperature of 700 °C, stretch velocity of 5 mm/min, post stretch percentage of 2% and dwelling time of 8 min are achieved finally.


Key words: Ti-6Al-4V alloy; hot stretch-creep forming; springback; orthogonal experiment; optimization

ISSN 1004-0609
CN 43-1238/TG

ISSN 1003-6326
CN 43-1239/TG

主管:中国科学技术协会 主办:中国有色金属学会 承办:中南大学
湘ICP备09001153号 版权所有:《中国有色金属学报》编辑部
地 址:湖南省长沙市岳麓山中南大学内 邮编:410083
电 话:0731-88876765,88877197,88830410   传真:0731-88877197   电子邮箱